FortiMail-4000
© Copyright 2008 Fortinet Incorporated. All rights reserved.
Products mentioned in this document are trademarks or registered trademarks
of their respective holders.
Regulatory Compliance
FCC Class A Part 15 CSA/CUS
9 September 2008
06-30004-0333-20080909
Checking the Package Contents
Front
Back
Ethernet Cables:
Orange - Crossover
Grey - Straight-through
UID
Null-Modem Cable
(RS-232)
Power
Connection
Serial Connection
Ethernet Connections
Power Cable
Connector
Ports 1 and 2
CONSOLE
Type
RJ-45
DB-9
Speed
Protocol
Description
Connection to the network
10/100Base-T Ethernet
Q u i c k S t a r t G u i d e
9600 bps
RS-232 serial Connection to the management computer. Provides
FortiMail-4000
access to the command line interface (CLI).
Copyright 2006 Fortinet Incorporated. All rights reserved.
Trademarks
Products mentioned in this document are trademarks.
Documentation
Connecting
Connect the FortiMail unit to a power outlet and to the network hub or switch.
•
•
•
•
Place the FortiMail unit on a stable surface The FortiMail-4000 requires 1.5 inches
(3.75 cm) clearance on each side to allow for cooling.
Alternatively, install the FortiMail-4000 in a 19-inch rack. The FortiMail-400 requires 2U
of vertical space.
UID
Power
Connection
Make sure the power is not plugged into the wall before connecting the power cable to
the FortiMail unit.
Straight-through Ethernet cable connects
to hub or switch on the network
Null modem cable connects
to serial port on management computer
Once you connect the power cord to the FortiMail unit, plug the cord into the outlet.
Planning the Configuration
Gateway mode
Transparent mode
In Gateway mode, the FortiMail unit protects your email server by scanning the SMTP traffic
In Transparent mode, the FortiMail unit protects your email server by scanning the SMTP
for viruses and spam messages as it passes through the FortiMail unit.
traffic for viruses and spam messages as it passes through the FortiMail unit.
You can configure your firewall or DNS server to ensure that incoming SMTP traffic goes
through the FortiMail unit before reaching the email server. Optionally, you can configure the
email server to use the FortiMail unit as the relay server for outgoing SMTP traffic.
The FortiMail unit provides seamless integration into existing networks. You can place the
FortiMail unit in front of the existing email server without any configuration changes to the
existing network topology, for filtering email messages. This means that all of the FortiMail
interfaces are on the same IP subnet and appears to other devices as a bridge. Alternatively,
you can configure the FortiMail unit as a combination of a bridge and a router by assigning
IP addresses to some of its interfaces. In this situation, the interfaces can be on different
subnets.
The FortiMail unit integrates into your existing network with only minor changes to your
network configuration.
Server mode
In Server mode, the FortiMail unit provides basic email server functionality, supporting
WebMail, SMTP, POP3 and IMAP email protocols. In addition, the FortiMail Server provides
antivirus, antispam, email archiving, logging and reporting services.
|