ALTERNATIVE INSTALLATION
900mm ActiveSmart™ Slide-in Refrigerator
Model no:
RS90A1
Custom Panel Dimensions
mm
698
50
aHeight of bottom drawer panel
BMinimum height of toekick panel*
CMinimum depth of toekick panel
50
* The bottom drawer panel can be extended lower to cover the grille. However
in this installation scenario the product needs to be raised a minimum of
50mm from the floor to allow for adequate air supply.
Note: this alternative installation will cause some restriction of air supply so
the fridge will not be operating at it’s optimum energy performance levels.
A
A
Additional Part (Air Splitter) Dimensions
DOverall height of block
mm
80
120
25
B
EOverall width of block
FOverall depth of block
GHeight from bottom of door panel to bottom of block*
HDistance from left edge of panel to centre of block**
5
360
C
* Presumes door panel height of 698mm
** Note measurement given from left when panel viewed from rear
B
Block to be manufactured and fitted by cabinetmaker., it can be construced
out of MDF or similar material
ISO VIEW
PROFILE VIEW
Bottom door panel and block need to be adequately sealed to withstand
moisture (50OC @ 80% RH). The back and sides of the panel should be
completely sealed with a waterproof vapour barrier (ie polyurethane) to
prevent damage to the panel
INDICATES CAVITY CLEARANCES
AIR SPLITTER BLOCK
OPTIMISES AIR FLOW IN
AND OUT OF GRILLE
DATE: 11.06.2015
G
F
IMPORTANT NOTE: Throughout this guide, dimensions may vary by 2mm
(3/32''). Please read the installation manual for detailed information on
H
E
D
REAR VIEW OF BOTTOM PANEL
|