COSMIC
COSMIC
CL 95/CL 125
®
• Plug laminator into
power outlet.
• Position laminator
so you have enough
space to allow items to
pass freely through the
machine.
Use Fellowes brand
pouches for best results.
Select correct pouch size for
laminated item.
CAUTION: Only use self-adhesive pouches when laminating with a cold setting.
Peel a small part of the protective Place pouch, sealed edge first,
To prevent jamming, immediately
Center item on clear side against
sealed edge; documents cannot
be repositioned once laminated.
Slide power button to Cold
Setting and wait for green Ready
Light.
sheet away from document.
into laminator entry. Keep pouch remove laminated item from back
straight and use the edge guide
to center it. Continue peeling the
protective sheet away.
of machine.
Place pouch, sealed edge first,
into laminator entry. Keep pouch
straight and use the edge guide
to center it.
To prevent jamming, immediately Before switching off laminator,
remove laminated item from back feed empty cleaning/carrier sheet
of machine. Let item cool on flat through machine to clean unit.
surface for several seconds.
Place item inside pouch against
the sealed edge. To prevent jam-
ming, use a carrier when item is
smaller than the pouch.
Slide power button to Hot
Setting and wait for green
Ready Light.
Problem
Cause
Solution
Ready Light does not go on after extended Laminator is in a hot, humid area.
time.
Move laminator to a cool dry area.
Need Help?
Ready Light does not go on for cold
lamination.
Wait 90 minutes for laminator to fully cool down.
If you used the hot lamination setting before a cold lamina-
US: 1-800-945-4545
tion session, the laminator may need time to cool down.
Canada: 1-800-665-4339
México: 1-800-234-1185
Pass through laminator a second time.
Laminated item may be too thick.
Pouch did not completely adhere to item.
Jamming
Press release lever, in back of laminator, to gently pull pouch
out of machine. Use cleaning sheet before laminating.
Laminated item was not immediately removed from
machine or small items were laminated without a carrier.
Let our experts help you with a solution. Always
call us first before contacting your place of
purchase.
Always put item in a pouch.
Pouch was not used.
Align sealed edge with Pouch/Document Entry. Use guide
to center.
Pouch was not centered or straight when fed through
Pouch/Document Entry.
Fellowes warrants all parts of the laminator to be free of defects in material and workmanship for TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. IN NO EVENT SHALL FELLOWES BE
2 years from the date of purchase by the original consumer. If any part is found to be defective
during the warranty period, your sole and exclusive remedy will be repair or replacement, at
LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES ATTRIBUTABLE TO THIS PRODUCT.
This warranty gives you specific legal rights. You may have other legal rights that vary from this
Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, warranty. The duration, terms and conditions of this warranty are valid world-wide, except where
mishandling or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANT- different limitations, restrictions or conditions may be required by local law. For more details or to
ABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
obtain services under this warranty, please contact us or your dealer.
Help Line
Australia
+ 1-800-33-11-77
+ 1-800-234-1185
México
Benelux
+ 31-(0)-76-523-2090
Deutschland
España
+ 49-(0)-5131-49770
+ 34-91-748-05-01
+ 33-(0)-1-30-06-86-80
+ 39-071-730041
France
Italia
Japan
+ 81-(0)-3-5496-2401
+ 82-(0)-2-3462-2884
+ 60-(0)-35122-1231
+ 48-(22)-771-47-40
+ 65-6221-3811
Korea
Malaysia
Polska
Singapore
United Kingdom
+ 44-(0)-1302-836836
1789 Norwood Avenue, Itasca, Illinois 60143-1095 • USA• 630-893-1600
Australia
Benelux
Canada
China
Deutschland
España
France
Italia
Japan
Korea
Polska
Singapore
United Kingdom
United States
2006 Fellowes, Inc. Part No. 401503
|